Connecticut DMV CDL General Knowledge Practice Test 9
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. At the end of the day you find no defects on a property carrying vehicle. What does the federal rule require?
Show answer
Answer B: No written report is required, although the carrier may still ask for one
For property carrying vehicles the report is required only when a defect or deficiency is found or reported, although a carrier may impose a stricter policy.
-
2. How does a typical escape ramp stop a runaway vehicle?
Show answer
Answer B: With a bed of loose gravel or sand, often on an upgrade
Escape ramps use deep loose material, usually combined with a rising grade, so the vehicle is slowed gradually instead of being stopped by impact.
-
3. What information does an inspection decal on a commercial vehicle carry?
Show answer
Answer B: The date of the inspection, where the inspection report is kept, and information identifying the vehicle
The decal shows when the inspection was done, the name and address of the entity that holds the inspection report, and which vehicle it belongs to, so an officer can confirm the inspection at a glance.
-
4. How does overloading affect the way a vehicle drives?
Show answer
Answer C: It slows the vehicle on upgrades, makes stopping take longer and can overheat the brakes on downgrades
Extra weight demands more from the engine and the brakes, so the vehicle climbs slowly and needs much more distance to stop.
-
5. What does the tachometer on the dashboard of a heavy truck show?
Show answer
Answer D: How fast the engine is turning, in revolutions per minute
The tachometer reads engine speed in rpm, which is what a driver uses to judge shift points in a vehicle with a manual transmission.
-
6. Your drive wheels start to spin and the rear begins to slide while you accelerate on a slick surface. What should you do?
Show answer
Answer B: Stop accelerating and, if the vehicle has a manual transmission, push in the clutch
An acceleration skid ends when the drive wheels stop pushing, so easing off the throttle and disengaging the clutch lets them regain grip.
-
7. For a modern truck with low-friction parts and a streamlined shape, which gear should be used going down a grade?
Show answer
Answer D: A gear lower than the one needed to climb the same grade
Newer trucks roll more freely than older ones, so the old rule of using the climbing gear no longer holds; a lower gear is needed for enough engine braking.
-
8. You drop your phone on the floor of the cab while driving. What do federal rules require?
Show answer
Answer A: Leave it, because reaching for it while driving is banned
Federal rules forbid reaching for a mobile device in any way that takes the driver out of a seated, belted driving position.
-
9. What should you do with the previous driver vehicle inspection report before starting your trip?
Show answer
Answer B: Review it and confirm that listed defects were certified as repaired or as not needing repair
Reviewing the last report and the carrier certification tells you whether reported defects have been corrected before you take the vehicle out.
-
10. Part of your load stands high enough to hide a rear lamp or a reflector. What must be done?
Show answer
Answer B: The load must be moved or extra lamps fitted so the required lights can be seen
Required lamps and reflectors must remain visible; if the cargo blocks them, the load is rearranged or additional lamps are fitted so the vehicle can still be seen.
-
11. Cargo falls from your trailer and causes a crash behind you. Who is likely to answer for it?
Show answer
Answer C: The driver and the carrier, since securing the load on the road is their duty
Whoever loaded the vehicle, the driver and the carrier are responsible for the load being secure while it is on the road.
-
12. What is the driver looking for when the exhaust system is inspected?
Show answer
Answer B: Loose, broken or missing pipes, brackets or clamps, and signs that exhaust is leaking
A loose or leaking exhaust system can send carbon monoxide into the cab and can put hot gas against parts that will burn.
-
13. What speed and gear should be used when backing a large vehicle?
Show answer
Answer B: As slowly as possible, in the lowest reverse gear
Backing slowly in the lowest reverse gear keeps the vehicle under precise control and leaves time to correct the path.
-
14. What is checked in step six of the seven-step method?
Show answer
Answer D: The turn signals and the stop lights, checked from outside the vehicle
Step six returns to the cab to switch on the signal and stop lamps, then checks each one from outside, because those lamps are not lit during the earlier light check.
-
15. Why should the radiator cap never be removed while the engine is hot?
Show answer
Answer A: The cooling system is under pressure and scalding coolant can be sprayed out
A hot cooling system holds pressurized coolant above its normal boiling point, so releasing the cap can throw boiling liquid and steam at whoever is holding it.
-
16. What tells a driver when to shift up in a vehicle with a manual transmission?
Show answer
Answer C: Engine speed in rpm together with road speed
Shift points are judged from engine rpm and road speed, using the operating range the manufacturer specifies for that engine.
-
17. A commercial vehicle stops on the shoulder of a one-way or divided highway. Where do the three warning devices go?
Show answer
Answer A: At 10 feet, 100 feet, and 200 feet back toward approaching traffic
Traffic arrives from one direction only, so all three devices are set back toward it at 10, 100, and 200 feet, and they must be out within ten minutes.
-
18. What actually lowers the amount of alcohol in the bloodstream?
Show answer
Answer B: Time
The liver removes alcohol at a fixed rate, so nothing but the passage of time reduces blood alcohol concentration.
-
19. Your axle weights are legal, but the tires on that axle are rated below the weight it is carrying. What controls?
Show answer
Answer B: The lower figure, so the tires may not be loaded beyond their marked rating
You may never exceed the rating marked on a tire, even when the axle limit would allow more, because an overloaded tire builds heat and can fail.
-
20. What is the purpose of blocking placed against cargo on a trailer deck?
Show answer
Answer B: To fill the space around the cargo so it cannot slide
Blocking is shaped to fit snugly against the cargo and fastened to the deck, removing the room the load would need in order to move.
-
21. What is the maximum fine when a Connecticut move over violation injures an occupant of an emergency vehicle?
Show answer
Answer C: 2,500 dollars
An ordinary violation is an infraction, but injuring an occupant of an emergency vehicle raises the fine to as much as 2,500 dollars, and a death raises it to 10,000 dollars.
-
22. Rust streaks are running outward from the lug nuts on one wheel. What does this most likely indicate?
Show answer
Answer C: The lug nuts may be loose
Rust trails spreading from the nuts are a classic sign that the nuts have worked loose and the wheel has been moving on the studs.
-
23. What color must the clearance and side marker lamps and reflectors at the front of a trailer be?
Show answer
Answer A: Amber
Amber marks the front and the forward part of the sides of a vehicle, while red marks the rear, so another driver can tell which way the vehicle is facing.
-
24. Why should the mirrors be checked repeatedly while you make a tight turn?
Show answer
Answer C: To watch the rear of the vehicle clear other vehicles and objects
In a long vehicle the rear wheels cut inside the path of the front wheels, so only the mirrors show whether the rear is clearing curbs, poles and other vehicles.
-
25. You are backing with a helper guiding you and the helper drops out of sight in your mirror. What should you do?
Show answer
Answer B: Stop until you can see the helper again
If you cannot see the helper you cannot receive a signal to stop, so the only safe action is to halt until visual contact is restored.
-
26. Which of these is a suspension defect you must look for during the walkaround?
Show answer
Answer D: Cracked or broken spring leaves, loose or broken U-bolts, or leaking air suspension bags
Broken springs, failed U-bolts and leaking air bags let the axle shift or the body drop, which can make the vehicle impossible to control.
-
27. A driver behind you wants to pass and you can see that the road ahead is clear. What should you do?
Show answer
Answer B: Do not signal the other driver to pass; let that driver decide when it is safe
Directing other drivers can cause a crash if you misjudge the gap, so leave the decision to the driver who is passing.
-
28. Which brake lining condition must be reported?
Show answer
Answer C: Linings that are worn thin, loose, cracked or soaked with oil or grease
Linings must have enough material left and must be securely attached and clean, because a thin, loose or contaminated lining cannot deliver its share of braking.
-
29. Your brakes have failed on a downgrade and there is no escape ramp in sight. What is the best choice?
Show answer
Answer A: Steer into an open field or onto a side road that flattens out or climbs uphill
A flat or uphill escape route uses gravity and rolling resistance to stop the vehicle; take it as soon as you see it, because the longer you wait the faster you go.
-
30. In very hot weather, how often should you check the tires during a trip?
Show answer
Answer D: About every two hours or every 100 miles
Heat raises tire pressure and can lead to blowouts, so tires are checked about every two hours or 100 miles when it is very hot.
-
31. How soon must warning devices be placed after a commercial vehicle stops on the traveled part or the shoulder of a highway?
Show answer
Answer D: As soon as possible and in any case within 10 minutes
The hazard warning flashers go on immediately and the warning devices must be in place as soon as possible, never later than 10 minutes after stopping.
-
32. How should a driver use brakes fitted with an antilock system during an emergency stop?
Show answer
Answer C: Brake as usual and keep enough pressure to stay in control while steering around the hazard
The system only works when the brakes are applied hard enough for it to act, so the driver keeps pressure on and steers while the system prevents lockup.
-
33. You are on a freeway and see brake lights come on in several vehicles far ahead of you. What should you do?
Show answer
Answer A: Ease off the accelerator and get ready to slow down
Brake lights well ahead are an early warning that traffic is slowing, and acting on them gives a heavy vehicle the room it needs.
-
34. How should the steering wheel be held when driving a large vehicle?
Show answer
Answer D: Firmly with both hands, placed on opposite sides of the wheel
Both hands on opposite sides give the leverage and control needed if a tire drops off the pavement or the wheel is jolted.
-
35. What is the minimum tread depth required in every major groove of a steering axle tire?
Show answer
Answer D: 4/32 inch
Federal rules set a higher tread minimum for front steering tires than for other positions because a steering tire failure is far harder to control.
-
36. What should the ammeter or voltmeter show once the engine is running?
Show answer
Answer D: A reading in the normal charging range
With the engine running, the alternator should be charging; a discharge reading or an abnormal charge level means an electrical fault.
-
37. On the Interstate System, what are the federal maximums for a tandem axle group and for gross vehicle weight?
Show answer
Answer B: 34,000 pounds and 80,000 pounds
The federal Interstate limits allow 34,000 pounds on a tandem axle group and 80,000 pounds gross.
-
38. Loading heavy freight on top of lighter freight has what effect on the vehicle?
Show answer
Answer B: It raises the center of gravity and makes a rollover more likely
A high center of gravity lets the vehicle tip more easily in curves or during a sudden swerve.
-
39. Most rollovers of loaded trucks on exit and entrance ramps happen for which reason?
Show answer
Answer B: The ramp was taken faster than the load could tolerate
A posted ramp speed is set for cars, and a loaded trailer with a high center of gravity can roll at a speed a car would take easily.
-
40. Why does a load need to be balanced from side to side?
Show answer
Answer B: Because a heavy side raises the rollover risk and can overload the tires and springs on that side
An uneven load tips the balance of the vehicle in curves and pushes the tires and suspension on the loaded side past their rating.
-
41. An enforcement officer inspects your vehicle at the roadside and attaches an out-of-service sticker. What may you do?
Show answer
Answer C: Nothing until the defect is repaired; the vehicle may not be driven
An out-of-service order means the vehicle is unsafe, and no schedule, load or destination allows it to be driven before the defect is corrected.
-
42. You are making a right turn and cannot complete it without swinging into the oncoming lane. An oncoming car is approaching. What should you do?
Show answer
Answer A: Wait and let the oncoming vehicle pass before completing the turn, and do not back up
The oncoming vehicle has the lane; backing up in traffic is dangerous, so hold your position and finish the turn once the way is clear.
-
43. An oncoming vehicle at night has bright headlights that are making it hard to see. What should you do?
Show answer
Answer B: Look toward the right edge of your lane and avoid looking directly at the lights
Looking at the right edge of the road keeps your eyes off the glare while you stay in your lane; glare can leave you nearly blind for several seconds.
-
44. How can a driver tell that a shipment includes hazardous materials?
Show answer
Answer B: The shipping paper describes them and the packages carry hazard warning labels
Hazardous materials are identified on the shipping paper with their shipping name and hazard class, and the packages themselves carry labels showing the hazard.
-
45. What does the working load limit stamped on a chain or strap describe?
Show answer
Answer B: The maximum load the device is rated to hold in normal use
The working load limit is the rated safe capacity for everyday use, deliberately set well below the force that would break the device.
-
46. During a stop you find a package in the trailer leaking an unknown chemical. What should you do?
Show answer
Answer C: Keep clear, keep others away and get help without touching the package
A driver without the training and equipment does not handle a leak; the job is to protect people from the material and get qualified help to the scene.
-
47. If an intersection has two lanes marked for left turns, which one should a large vehicle use?
Show answer
Answer D: The right hand of the two turning lanes
The outside turning lane leaves room for the rear of the vehicle to swing without striking a vehicle in the adjacent lane.
-
48. Federal rules forbid operating a commercial vehicle in which condition?
Show answer
Answer C: In a condition likely to cause a crash or a breakdown
A defect that makes a crash or a breakdown likely has to be corrected before the vehicle is driven, not reported at the end of the trip.
-
49. What do the U-bolts on a leaf spring suspension do?
Show answer
Answer A: They clamp the spring assembly to the axle so it cannot move
U-bolts hold the spring pack tight against the axle, and a loose or broken U-bolt lets the axle slide out of place under load.
-
50. At a stop on a hot day you find a tire that is too hot to touch. What should you do?
Show answer
Answer C: Wait until the tire cools before driving on, and do not let air out of it
A tire that is too hot to touch may be about to fail or catch fire; releasing air only leaves it underinflated once it cools, which makes things worse.